Fishnhunt New Zealands main hunting and Fishing Forum. millions of posts on fishing and hunting, dogs, 4x4 vehicles, outdoors and much more Welcome, Guest. Please Login or Register
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Transducer mounting and beach launching (Read 354 times)
Rudolph Red Nose
Full Member
***
Offline


I Love The FishNhunt Forum

Posts: 189
Location: Nelson
Joined: Jul 5th, 2011
Gender: Male
Transducer mounting and beach launching
Jul 1st, 2018 at 5:09pm
Print Post  
Hi Fellas,
I upgraded to a slightly bigger tinny (Stabi 383 Pontoon) and while at it also installed one of these shiny fishfinder/scanner numbers (Lowrance Hook 2 triple shot).
Turns out the transducer is pretty long. Me thinks long enough to get in the way of launching the little Stabi at a shallow beach (and getting it back on the trailer). As the angle of the boat putting it in/out of water would no doubt be steep enough to "bend" the transducer. So far, launched only at ramps and this does of course not create a problem.
Anyone come across the same problem and came up with a bright solution to either:

- have a "quick release and re-attach"
or
- being able to fold it back vertically against the boat and fold it back down again then in deeper water  ???
Cheers in advance
  
Back to top
 
IP Logged
 
tim41
Active Member
**
Offline


I Love The FishNhunt Forum

Posts: 81
Location: taupo
Joined: Feb 11th, 2011
Gender: Male
Re: Transducer mounting and beach launching
Reply #1 - Jul 6th, 2018 at 5:15pm
Print Post  
have it mounted so you can lift it up out of the way and the reach over and push it back down once your in deep water,on mine ive just left the mounting bolt where the trans bolts to the bracket on the boat loose enough do do this
  
Back to top
 
IP Logged
 
Rugersst
Forum Font
*****
Offline


Victory is mine...

Posts: 1391
Location: Pilbara WA
Joined: Nov 8th, 2010
Gender: Male
Re: Transducer mounting and beach launching
Reply #2 - Jul 8th, 2018 at 2:05am
Print Post  
A Gopro mount works a charm on my creek tinny.
  
Back to top
 
IP Logged
 
Rudolph Red Nose
Full Member
***
Offline


I Love The FishNhunt Forum

Posts: 189
Location: Nelson
Joined: Jul 5th, 2011
Gender: Male
Re: Transducer mounting and beach launching
Reply #3 - yesterday at 4:04pm
Print Post  
Gives me a couple of ideas. Rugersst, would you be able to post a link to such a gopro mount - seem to be A LOT of different ones around Smiley
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
 

FishnHunt - New Zealands Famous Hunting and Fishing Forum Since 1995 » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2018. All Rights Reserved.
Site Design By Alan Simmons - PRism and all rights are reserved from 1995 and onwards